Advertisement
Machined area record
Enter the aggregation setting menu.
Check whether the proper user and aggregation width (1) are adjusted or perform setting of the user and
aggregation width. Each user has their values of the processed area; when the user is changed, values valid
for the selected user are displayed on the main screen.
Use the buttons (C) and (D) to select the item (2) and press the button (B) to start the record of the
processed area (the item is marked by the tick).
From now, if the tractor is moving, the processed area will be recorded depending on the aggregation width
and the covered distance.
The processed area is recorded only in the case that the arms of the rear three-point hinge are
lowered in the working position.
The record of the processed area ends if in the processed area menu you use the buttons (C) and (D) to
select the item (3) and press the button (B) to end the record of the processed area (the item is marked by
the tick).If you start the record of the processed area again, the newly read values are added to the values
already stored.
If it is necessary to change the user during recording of the processed area, end the recording of the
processed area, perform selection of another user and aggregation width, start record of the processed area,
newly read values are added to the values already stored for the newly selected user.
Use the buttons (C) and (D) to select the item (4) and press the button (B) to reset the values of the
processed area for the selected user.
Use the buttons (C) and (D) to select the item (5) and press the button (B) to reset the values of the
processed area for all users.
After return to the main screen of the processed area, there will be no data in the display field.
The reset values cannot be restored any other way.
INSTRUMENT PANEL
PHS18N012
70
Advertisement
