Advertisement
MAINTENANCE INSTRUCTIONS
Reassembly of the air cleaner elements
When reassembling the air cleaner elements proceed in
the reverse order.
Observe the following points during the element
reassembly:
- Make sure the contact surfaces are clean.
- During the assembly the elements must not get
deformed and after installation they must not vibrate.
- After closing of the cleaner with the lid the whole cleaner
must be perfectly leak-proof.
- After the maintenance of the dry air cleaner ensure
proper functioning of the clogging indicator again.
G715
Bleeding the hydraulic circuit of the hydrostatic steering
1 - Start the engine and let it run at the idle speed for
approx. 1 minute.
2 - Turn the steering wheel several times to both the sides
at the idle speed of the engine.
3 - At the maximum engine speed turn the wheels with the
steering wheel 3 times alternately slowly and quickly to
both the sides up to the limiting stops of the wheels.
4 - Stop the engine and lower the tractor onto the front
wheels.
F11N035
187
Advertisement
