Advertisement
Bleeding the rear brake system
Should be performed with the started engine and connected brake pedals according to the following
procedure:
1. Remove the rubber cap, install the hose on the bleeder screw (1) and immerse the other end to the bottom
of the transparent vessel partly filled with the oil that forms the filling of the gearbox. The bleeder screw must
be permanently under pressure to prevent air penetration through its threads, therefore when doing this
place the vessel at least 300 mm above the bleeder screw.
2. Release the bleeder screw by 1/4 revolution max.
3. Press down the connected brake pedals and tighten the bleeder screw.
4. Release the brake pedal and repeat the procedure until no air bubbles come out of hose.
5. Remove the hose from the bleeder screw and install the rubber cap back on it.
6. Follow the same procedure for bleeding the screw (2).
Bleeding of the brakes of the front wheels
Should be performed with the started engine and connected brake pedals according to the following
procedure:
1. Remove the rubber cap, install the hose on the bleeder screw (1) on the left reductor of the front axle and
immerse the other end to the bottom of the transparent vessel partly filled with the oil that forms the filling of
the gearbox. The bleeder screw must be permanently under pressure to prevent air penetration through its
threads, therefore when doing this place the vessel at least 300 mm above the bleeder screw (2).
2. Release the bleeder screw by 1/4 revolution max.
3. Press down the connected brake pedals and tighten the bleeder screw.
4. Release the brake pedal and repeat the procedure until no air bubbles come out of hose.
5. Remove the hose from the bleeder screw and install the rubber cap back on it (3).
6. Follow the same procedure for bleeding the brake of the right front wheel with the bleeder screw on the
right reductor of the front axle.
ADJUSTMENT
F18N060
P18N088
198
Advertisement
