Advertisement
MAINTENANCE INSTRUCTIONS
Filling the engine with oil
Pour the prescribed quantity of engine oil into the filling
opening (2), start the engine and let it run for 2 - 3 minutes
at 750 - 800 rpm. After stopping of the engine and level
stabilization use the dipstick (1) to check the oil level and
check the cleaner, drain plug (3) and other joints for leaks.
H196
Replacement of carter exhaust oil separator filter element
Oil separator is placed on engine's right hand side and is
accessible when lifting the hood. To replace the filter
element dismount four bolts (1) and separator cover (2).
Pull the element (3) to remove it. Clean the inside surface
of separator first and verify the function of reverse valve,
placed in the separator cover, then place back a new filter
element. Verify the correct position of filter element seal,
mount back the separator cover and tighten four bolts (1).
FHD15N014
Replacing the fuel filter element
Replace the filter element after releasing the nut (1) and
unscrewing the bowl (2). During the re-assembly of the
cleaned bowl with the new filter element check proper
seating of the bowl gasket. Bleed the fuel system. During
the cleaning and replacement of the filter elements place
a suitable vessel under the engine to catch dripping fuel.
F238
184
Advertisement
