Upgrading The Camera's Firmware; Accessing The Camera From A Web Browser - Honeywell equIP Series User Manual

2MP/4MP Low Light WDR IP Camera User Guide
2. Click the Network tab.
3. Clear the DHCP check box.
4. Enter the new IP settings in the IP Address, Subnet Mask, and Default Gateway fields.
5. Click Apply to apply the settings.
To change the IP addresses of multiple cameras at the same time:
1. In the left-most pane of the IPC Tool utility, click Batch Setting.
2. Select all of the cameras that you want to configure from the devices list.
3. Click the Network tab.
4. Do one of the following:
•
To assign dynamic IP addresses, select the Set all to DHCP check box, and then click
Apply.
•
To assign static IP addresses, enter the settings in IP Range, Subnet Mask, and
Default Gateway fields, and then click Apply.

Upgrading the Camera's Firmware

Before you begin using your camera, make sure you have the latest firmware installed. You
can upgrade a single camera or multiple cameras at the same time.
To upgrade a single camera:
1. Select the camera that you want to upgrade from the devices list.
2. Click the Upgrade tab.
3. Click Browse, navigate to the directory that contains the firmware file (.bin), select the file,
and then click Open. The firmware file appears in the Target File field.
4. Click Upgrade. When the upgrade is complete, the camera will reboot.
To upgrade multiple cameras at the same time:
1. In the left-most pane of the IPC Tool utility, click Batch Setting.
2. Select all of the cameras that you want to upgrade from the devices list.
3. Click the Upgrade tab.
4. Click Browse, navigate to the directory that contains the firmware file (.bin), select the file,
and then click Open. The firmware file appears in the Target File field.
5. Click Upgrade. When the upgrade is complete, the cameras will reboot.

Accessing the Camera from a Web Browser

To access the camera from a web browser:
1. Select the camera that you want to access from the devices list. The camera must be
online .
2