Configuring Camera Tampering Events - Honeywell equIP Series User Manual

2MP/4MP Low Light WDR IP Camera User Guide
generate an alarm output after the event has ended. Enter a value between 10 and 300.
To send an email notification when motion is detected, select the Send Email check box.
10.
Email settings must be configured in Setup  Network Setup  SMTP (Email). See
Configuring Email Settings
To take a snapshot when motion is detected, select the Snapshot check box.
11.
For the snapshot to be attached to the email notification, the
Note
Attachment check box must be selected in Setup > Network Setup
> SMTP (Email). See
Click Save to apply the settings.
12.

Configuring Camera Tampering Events

You can configure camera tampering event settings on the Setup  Onboard Video Analytics
 Video Detection  Video Tampering page.
To enable camera tampering detection:
Select the Enable Tamper Detect and/or the Enable Defocus Detect check box(es).
1.
Next to Alarm Period, click Setup. The Alarm Period window opens.
2.
Set the days and times when you want the alarm function to be active, and then click Save.
3.
To start recording video when a tampering event is detected, ensure that the Record check
4.
box is selected.
In the Record Delay field, enter the number of seconds that the system will continue to
5.
record video after a tampering event has ended. Enter a value between 10 and 300.
To generate an alarm output when a tampering event is detected, select the Alarm
6.
Output check box and select the alarm output(s) to be activated.
In the Alarm Delay field, enter the number of seconds that the system will continue to
7.
generate an alarm output after a tampering event has ended. Enter a value between 10
and 300.
To send an email notification when a tampering event is detected, select the Send Email
8.
46
on page 33.
Configuring Email Settings on page 33.