Configuring The Live Interface - Honeywell equIP Series User Manual

2MP/4MP Low Light WDR IP Camera User Guide

Configuring the Live Interface

The first time you log into the web client, follow the on-screen
Note
instructions to download and install the web browser plug-in.
You can configure the Live interface using the configuration controls located in the lower left
corner of the screen, immediately below the video window.
Figure 2-2 Live Configuration Toolbar
Table 2-1 Live Configuration Controls
Image
Adjustment
Original Size
Full Screen
Width:Height
Ratio
Fluency
Rules Info
6
Opens the Image Adjustment panel.
Move the sliders to adjust the image
brightness, contrast, hue, or
saturation. Click the – and + signs to
make fine adjustments. To restore the
settings to their default values (64),
click Reset.
Note These settings only apply to the client end. To change
the settings at the camera end, go to Setup  Camera
Setup  Conditions  Picture.
Displays the video at actual size (the exact dimensions are
determined by the stream resolution).
Displays the video in full-screen mode. Double-click (or
press Esc) to exit full-screen mode.
Displays the video in its original size (Original) or fitted to
your screen (Adaptive).
Sets the video fluency level (Realtime, Normal, or Fluency).
Select a fluency level based on the capabilities of your
network.
For example, if your connection is slow, selecting Fluency
will prioritize smoothness over image quality.
Tracks movement in the video window when intelligent
video surveillance (IVS) is enabled.