Configuring Smart Plan - Honeywell equIP Series User Manual

Next to Alarm Period, click Setup. The Alarm Period window opens.
3.
Set the days and times when you want the alarm function to be active, and then click Save.
4.
In the Anti-Dither field, enter the anti-dither time in seconds. Enter a value between 0 and
5.
100 seconds. The system will only allow one audio event within this period.
To start recording video when an audio event is detected, ensure that the Record check
6.
box is selected.
In the Record Delay field, enter the number of seconds that the system will continue to
7.
record video after an audio event has ended. Enter a value between 10 and 300.
To generate an alarm output when an audio event is detected, select the Alarm Output
8.
check box and select the alarm output(s) to be activated.
In the Alarm Delay field, enter the number of seconds that the system will continue to
9.
generate an alarm output after an audio event has ended. Enter a value between 10 and
300.
To send an email notification when an audio event is detected, select the Send Email
10.
check box. Email settings must be configured in Setup  Network Setup  SMTP
(Email). See
To take a snapshot when an audio event is detected, select the Snapshot check box.
11.
For the snapshot to be attached to the email notification, the
Note
Attachment check box must be selected in Setup  Network Setup
 SMTP (Email). See
Click Save to apply the settings.
12.

Configuring Smart Plan

Smart plan is a master switch for the intelligent analytics such as "Face Detection", "Heat
Map", "IVS" and "People Counting" etc. The device intelligent functions can be valid after
smart plan is enabled.
You can configure smart plan on the Setup  Event  Smart Plan page. Select the plan by
clicking its icon and click Save.
Configuring Email Settings
Configuring Email Settings
on page 33.
on page 33.
Configuring Event Settings
49