Configuring Network Connections - Honeywell equIP Series User Manual

2MP/4MP Low Light WDR IP Camera User Guide
Open the Command Prompt window on your PC (in Windows 7, click Start  All
4.
Programs  Accessories  Command Prompt) and type the appropriate commands
for your operating system:
Reboot the camera. If the setup was successful, the Command Prompt window will
5.
display "Reply from" and the IP address (for example, "Reply from 192.168.0.125 ...").
To verify that the IP address works, open your browser and type in the address bar http://
followed by the IP address (for example, http://192.168.0.125), then press Enter.

Configuring Network Connections

You can configure network connections and port settings on the Setup  Network Setup 
Connection  Connection page.
28