Specifications - EBARA CDX 70 Manual

CENTRIFUGAL PUMPS
SPECIFICATION
Type of liquid
Liquid
Handled
Temperature
Maximum working pressure
Impeller
Construction
Shaft seal type
Bearing
Pipe Suction
Connection
Discharge
Casing
Impeller
Casing cover
Material
Shaft seal
Shaft
Bracket
Applicable standard of test
Type
No. of Poles
Rotation speed
Insulation Class
Protection degree (CEI EN 60034-5)
Power rating
Frequency
Voltage
Capacitor
Over load protection
Casing material
Base material / Motor support
Dimensions of cable entry
PUMP
Clean water
min. -5
max. +60 (CDX 70/076-70/106-70/156)
[°C] max. +90
max. +110 (H-HS-HW-HSW)
max. +120 (E)
[MPa] 0.8
Closed centrifugal type
Mechanical seal
Sealed ball bearing
[inch] from G 1¼ to G 1½
[inch] G 1
EN 1.4301 (AISI 304) - (AISI 316 only for "L" version)
EN 1.4301 (AISI 304) - (AISI 316 only for "L" version)
EN 1.4301 (AISI 304) - (AISI 316 only for "L" version)
Ceramic/Carbon/NBR (for CDX)
Ceramic/Carbon/FPM (for CDXH)
SiC/SiC/FPM (for CDXHS)
Tungsten Carbide/Tungsten Carbide/FPM (for CDXHW)
SiC/Tungsten Carbide/FPM (for CDXHSW)
AISI 303 / AISI 316 (Wet extension)
Aluminium
ISO 9906 – Annex A
MOTOR
Single Phase
-1
[min ]
[kW] 0.55 ÷ 1.5
[HP] 0.75 ÷ 2.0
[Hz]
110-115 ±6%
[V]
220-230 ±6%
Built in
Built in
PG 11 - PG 13.5 (see dimensions page 400)
UNI ISO 228-1
UNI ISO 228-1
Electric - TEFC
Three Phase
2
≈ 3450
F
IP 55
0.55 ÷ 2.2
0.75 ÷ 3.0
60
220/380-460 -6% +10%
Provided by the user
Aluminium
Aluminium
EBARA
PUMPS EUROPE S.p.A.
CDX
60Hz
Rev. E
-
200