Status Led Error Code Table - Taylor-Dunn SS-025-34 Operation, Maintenance, And Replacement Parts Manual

Status LED Error Code Table

There are three status lights (LED's) on the charger name plate. These LED's normally indicate the current operating state of
the charger. If all three LED's are flashing, it indicate an error has occurred in the charging cycle. See the table below for an
explanation of the error codes:
Note: If only the 100% LED is flashing and all others are OFF then the charger has exceeded its maximum charging time
and shut off before the batteries were fully charged.
This could be a result of:
• Defective battery or batteries
• Excessively discharged batteries
• Oversize batteries
Error
Description
Code
Reverse polarity or open circuit to
1*
the batteries
AC line voltate too high or too
2
low
3 Charger overheated
4 Input or Output over current
* - In many cases fault 1 will only be displayed for a short amount of time and then the charger will attempt to restart. Typically,
the fault will repeat 8 times and then the charger will start the boot up process with the 50% light on. If the charger cannot restart
then the fault loop will start again, repeating the fault 1.
This fault could be a result of an open connection between the charger and batteries, an open connection on one or more of the
battery cables, or an open connection internal of the charger.
Before replacing the charger, confirm all battery wiring is good.
Action Required
Check wiring for corrosion, loose connections. broken wires and
proper connection to the batteries
Check the input voltage.
It must be within 96-132VAC or 196-266VAC
Wait for charger to cool, the charger will automaticaly restart. Inspect
for dirt or debris on the charger cooling fins and clean as required.
Charger will automaticaly correct for this condition and restart
Battery Charger
Page 21