Settings; Setting The Parameters; List Of Parameters - DeDietrich AMC 15 Installation And Service Manual

9 Settings

9 Settings
9.1

Setting the parameters

Fig.85 Parameters, counters, signals
9.2

List of parameters

84 AMC
You can change the parameters and settings of the appliance and the
connected control boards, sensors etc. to configure the installation.
A
The boiler's control unit is set for the most common central heating
systems. These settings will ensure that virtually every central heating
system operates effectively. The user or the installer can optimise the
parameters as required.
B
AD-3000936-01
The parameters are arranged in three levels:
1
2
3
The code of the parameters always contain two letters and three numbers.
The letters stand for:
AP
CP
DP
GP
PP
1. Press the button.
2. Select > Installation Setup.
3. Select the zone or device you want to configure.
4. Select Parameters, counters, signals > Parameters to change a
parameter.
5. If available, select Adv. Parameters to change a parameter at the
advanced installer level.
A Parameters
Counters
Signals
Adv. Parameters
Adv. Counters
Adv. Signals
B List of settings or values
Caution
Changing the factory settings may adversely affect the operation
of the boiler.
End user level
Installer level
Advanced installer level
Appliance related parameters
Zone related parameters
Domestic hot water related parameters
Gas fired heat engine related parameters
Central heating related parameters
Important
All possible options are indicated in the adjustement range. The
display of the boiler only shows the relevant settings for the
appliance.
7686707 - v.01 - 06092018