Label Position; Platform Position - Primera AP550e Operator's Manual

3.5 Label Position

This setting will adjust the distance the label stock extends past the peel edge. You may adjust
this setting +/– 8.1 mm. Use the +/– buttons to adjust the position. Press "Recall/Reset" to
store the position in the current memory location. Depending on your container and the angle
of the Application Arm, you may change this setting to achieve a more consistent label position
on the container.
Note: For some thinner label stock, if the Label Position is increased too much, the label could fold or
wrinkle at the leading edge.

3.6 Platform Position

The location of the label applied to the container in the direction of Container Platform
movement can be adjusted by changing the start position of the platform. To determine the
correct Container Platform start position:
1.
2.
16 AP550e Label Applicator
Place your container on the platform, push the container back until it touches the back edge
of the platform.
At the "Platform Position" [PPo] setup option, press the +/– buttons to adjust the starting
Peel Edge
2.50" Start Position
6" Container
Application Roller
Label
Label Position
[distance from peel edge]
Leading Edge of Label
Container Platform