Section 4: Applying Labels - Primera AP550e Operator's Manual

Section 4: Applying Labels

1. Press the Mode button to display the current memory location.
2. If needed, press the Recall/Reset button to index to the desired memory location.
3. Assuming the desired label stock is loaded (see Section 2), place a container on the platform.
4. Lower the Application Arm quickly until it touches the container. The platform and
Note: If you stop or delay when bringing the arm toward the container, the label could be ejected before
the arm reaches the container. Excessive force may cause the platform to stall.
6. Lift the Application Arm to return the platform to its starting position.
7. Remove the container and repeat the process.
The display will automatically indicate the number of labels applied. To reset the counter, press
and hold the Recall/Reset button for two seconds.
Hold the container biased against the back edge of the platform and Container Guide until
labeling begins.
container will move toward you as the label is pulled from the liner at the peel edge. This
motion will apply the label. Maintain downward force on the arm until the label is
completely applied.
Push here
AP550e Label Applicator 19