Control Panel Functions; Technical Support - Primera AP550e Operator's Manual

Test Mode
Note: Be sure to unload any label stock from the Liner Drive Roller before starting the Test Mode.
Turning Test Mode off

6.4 Control Panel Functions

Mode Button: Toggles the display between the label count and the current memory location.
Hold for two seconds to enter the Setup Mode for the currently displayed memory location.
Press to exit the Setup Mode.
Recall/Reset Button: Displays next memory location in Memory Mode. Indexes to the next
parameter in Setup Mode. Hold for two seconds to reset the label counter when in Label Count
Mode. Hold for two seconds to clear all the settings for the current memory location.
+ Button: Increments the current parameter when in Setup Mode. Hold to advance more
quickly. When the label count is displayed, hold for two seconds to increase the count.
– Button: Decrements the current parameter when in Setup Mode. Hold to advance more
quickly. When the label count is displayed, hold for two seconds to decrease the count.

6.5 Technical Support

If you have difficulties operating your applicator, the procedures in this manual and the
software User's Guide should, in most cases, solve the problem. If you still have difficulty,
contact Primera Technical Support using one of the methods listed below.
26 AP550e Label Applicator
1) Turn off the unit.
2) Press and hold the Recall/Reset and + button while switching on the unit.
3)The unit will now move the platform in and out and run the liner drive roller continuously.
1) Turn off the unit.
2) Press and hold the Recall/Reset and – button while switching on the unit.
Test Mode will be disabled.
Source
Primera Knowledge Base
Email Support
Phone Support
Location
www.primera.com/knowledgebase.html
sales@primera.eu
+49 (0)611 92777-0 (Mon - Thu 9 a.m. - 5 p.m., Fri 9 a.m. - 3 p.m. CET)