Table of Contents
Advertisement
Notices: The information in this document is subject to change without notice. NO WARRANTY OF ANY KIND IS MADE WITH
REGARD TO THIS MATERIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE. No liability is assumed for errors contained herein or for incidental or
consequential damages in connection with the furnishing, performance, or use of this material. This document contains proprietary
information that is protected by copyright. All rights are reserved. No part of this document may be photocopied, reproduced, or
translated into another language without prior written consent.
Trademark Acknowledgments: Primera is a registered trademark of Primera Technology Inc. Windows is a registered trademark of
Microsoft Corporation. All other trademarks are the property of their respective owners.
Printing History
Edition 1.1, 101113, Copyright 2013, All rights reserved.
FCC Compliance Statement: This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
For Users in the United States: This product is intended to be supplied by a UL listed Direct Plug-In Power Supply marked "Class 2"
or a UL listed ITE Power Supply marked "LPS" with output rated 12v, 5 amps or higher. This equipment has been tested and found
to comply with the limits for a "Class B" digital device, pursuant to Part 15 of the FCC Rules. In a domestic environment this product
may cause radio interference, in which case the user may be required to take adequate measures. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Re-orient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cables is required to comply with the "Class B" limits of Part 15 of the FCC Rules. You are cautioned that any changes
or modifications not expressly approved in this manual could void your authority to operate and/or obtain warranty service for this
equipment.
For Users in Canada: This digital apparatus does not exceed the "Class B" limits for radio noise for digital apparatus set out on the
Radio Interference Regulations of the Canadian Department of Communications. Le present appareil numerique n'emet pas de bruits
radioelectriques depassant les limites applicables aux appareils numeriques de la class B prescrites dans le Reglement sur le
brouillage radioelectrique edicte par le ministere des Communications du Canada.
Advertisement
Table of Contents
