Table of Contents
Advertisement
12. Feed the leading edge of
Note: Make sure the stock is
aligned so the labels pass under
the line marked on the push bar.
The line represents the location of
the label sensor. Also, if the label
stock has not been used before,
make sure the first label does not
extend beyond the Liner Drive
Roller, as shown.
13. Once the upper and lower label paths are aligned, press up on the middle of the Liner Idler
Liner Idler Roller
Liner Drive Roller
10 AP550e Label Applicator
the label stock under the
stock coming off the roll.
Align the leading edge of
the label stock so that it is
directly under the stock
coming off the roll. Pull it
tight.
Distance from
label stock to
arm side plate
should be equal
in these
locations.
Liner Drive Roller
Sensor Location Line
Roller firmly to lock the label stock in place. You will hear a "snap" when it locks into place.
Lock
Unlock
Align Here
Advertisement
Table of Contents
