Section 1: Unpacking And Setup - Primera AP550e Operator's Manual

Section 1: Unpacking and Setup

Thank you for purchasing the AP550e Label Applicator (hereafter referred to as "Label
Applicator"). Boxes, bags, bins, bottles, packages, cans etc. will collectively be referred to as
"containers."
The Label Applicator includes a Power Cord, 12 volt Power Adapter and the parts shown
below. The Roll Bar, Roll Guides and Roll Drag Arm are located in the supply box along with
the Power Cord. You will need to assemble them as shown. Attach the Power Cord and switch
on the power as shown below. Remove all tape securing parts of the unit.
Place the unit on the back edge of a table at least 30" deep so that the Container Platform does
not extend beyond the edge of the table when fully extended. This will prevent the platform
from accidentally hitting the user during operation.
Roll Drag Arm
Application Arm
Push Bar
Application Roller
Container Platform
4 AP550e Label Applicator
Power Switch
Power Input (12v)
Power Adapter
Roll Guides
Roll Bar
Control Panel
Container Guide
Power Cord