Application Arm Height Adjustment - Primera AP550e Operator's Manual

2.2 Application Arm Height Adjustment

The Application Arm basically consists of the upper half of the applicator. This entire assembly
can be moved manually to four different positions to accommodate various container heights.
The maximum container height is 20 cm. There is no minimum height other than the height
required to make the container stiff enough for labeling.* To move from one position to
another, squeeze the Pin Release Bar to move the pin out of the notch. Move the Application
Arm up or down until the pin snaps into the desired notch.
Note: When moving the Application Arm from one position to another, be sure to maintain upward
force at the front and rear of the arm. This will prevent the arm from falling when the Pin Release Bar is
squeezed and it will allow the arm to move more easily.
Pin Release Bar
* Containers less than 2 cm tall may require a riser to elevate the container above the back lip of
the platform. This will prevent the forward-moving platform from hitting the Application Arm.
Important! Set the height of the Application Arm as low as possible without causing any part of the
arm, other than the Application Roller, to touch the container or platform at any time during the
application process. Keep in mind that the Application Roller is pliable and will flex during application.
12 AP550e Label Applicator
Pin
Position Container Height
Notch 4 15-20 cm
Notch 3 10-15 cm
Notch 2 5-10 cm
Notch 1 0-5 cm
Application Roller and/or
label should touch container
first.
Container