Die Cut/Reflective - Primera AP550e Operator's Manual

Note 2: See Appendix B for a flowchart of the control panel menu.
With label count displayed,
To access the Setup Mode:
Below is a chart describing the label/container settings.
3.2 Die Cut / Reflective
Die Cut (default): If you are using standard die cut labels that look similar
to the labels pictured to the right, use this setting regardless of the size of
the label. Also use this setting for through-hole label material where a hole
is punched through each label or a notch is cut in the side (not common).
Reflective: Use "Reflective" for label material where a black pre-
printed line (black mark) on the back of the label stock indicates the
break between labels. Black marks are required on clear label stock
or where the label waste matrix is left on the liner. Black marks can
also be used for irregular-shaped labels or on any stock where the
print starting position cannot be sensed using the label itself.
14 AP550e Label Applicator
Recall/ Recall/
- -
+ +
Mode Mode
Reset Reset
press "Mode" once.
Text Displayed Settings
dIE/rEF Die Cut / Reflective Sets the label sensor for gap sensing or black mark
r-1/r-2 Application Roller
Position
SC- Sensor Calibration
LPo Label Position
PPo Platform Position
gPo Guide Position
S-1 to S-8 Platform Speed
Recall/ Recall/
- -
+ +
Mode Mode
Reset Reset
Hold "Mode" for 2 seconds.
Description
sensing.
Set to "r-1" for longer labels. Set to "r-2" for shorter
labels.
Calibrates the label sensor to the liner material.
Sets how far the label protrudes from the peel edge.
Adjusts the Container Platform start point.
Moves platform out for Container Guide adjustment.
Sets the Container Platform return speed between S1
and S8. S1 is slowest. S8 is fastest.
Die Cut Label Stock
Reflective Label Stock