Load Label Stock (Includes Attaching Stock To Rewinder) - Primera CX1000 Operator's Manual

TOC
Section 4: Load Label Stock
This section details the general process for installing label stock on the unwinder, and attaching the
label stock to the rewinder.
1. Switch on the unwinder, printer and rewinder.
Figure 4-1.
2. Place the label stock roll (max 8" OD) on the unwinder chuck. Push the stock all the way back
until it touches the stop disc.
Figure 4-2.
Note: You must use only 8.5 inch wide label stock in the CX1000. Failure to use specified label stock will
result in damage to your printer and excessive build up of toner and adhesive inside the printer.
Caution! You must use Primera approved label stock to avoid damage to your printer. Damage due to use of
unapproved material will not be covered by the warranty.
Unwinder
Stop Disc
ON
OFF
Printer
INDEX
Rewinder
Load Label Stock 15