Table of Contents
Advertisement
5.
6.
7.
6 AP550e Label Applicator
4. Place the Roll Drag Arm under the Roll Bar. The Roll Drag Arm may be placed on either
side of the Roll Bar but the rounded tip of the Roll Drag Arm should be located inside the
core near the center. The arm is spring loaded so that there is downward pressure on the
inside of the roll. This helps prevent problems toward the end of a roll.
Roll Drag Arm
Place the removed Roll Guide back on the Roll Bar and slide it close to, but not pinching the
label stock roll.
Pull approximately 12" [30 cm] of label stock out beyond the front of the unit.
Remove approximately the first 15" [38 cm] of labels from the liner. This will be important
later when you calibrate the label sensor to the label stock.
15"
[38 cm]
Tip! Roll Guide Uprights
must not pinch the label
stock roll. (The label stock
roll must have free-play
between the guides.)
Advertisement
Table of Contents
