Installing Harness System - Safety 1st Grow and Go Comfort Cool Manual

Installing Harness System

67
1
Fully Recline the Car Seat
Pull out on recline handle and push top
of child restraint back.
Insert Buckle's Metal Retainer into
2
Slot Closest to Child
Buckle must face out.
1
Rear-Facing
2
3
1st or 2nd buckle slots.
Forward-Facing
used.
Reach Under Seat Between Base
3
and Shell and Through Recline
Handle
Pull metal retainer completely through
pad and shell.
Check Buckle
4
Pull up on buckle to make sure it is
secured.
The buckle must not pull out.
Adjust Headrest to Highest Position
5
Mode: You must use the
Mode: Any slot can be
Undo Fasteners on Seat Pad and
6
Pull Headrest Pad Off Bottom of
Headrest
Unthread harness straps from slots
on side of headrest. Loosen harness
straps.
Pull chest clip, harness straps, and
buckle tongues out from behind the
headrest and seat pad.
Pull headrest pad down around
bottom of headrest.
Slide harness straps into slots in
headrest pad.
Attach seat pad fasteners.
If you have removed the harness straps from the splitter plate,
and the buckle tongues and chest clip have been unthreaded
from the harness straps, follow the steps below to rethread
them.
1
Thread Buckle and Chest Clip
Harness strap ends go through the
back of buckle tongues and through
the chest clip front to back as
shown.
68
continued on next page