Installing Harness System - Safety 1st SportFit 65 Instruction Manual

5. Undo Fastening Strip
Behind Headrest
Lower headrest to lowest
position and undo the
fastening strip behind the
headrest. Pull back pad
down from behind the
headrest.
6. Remove Seat Pad
Pull pad off the top of
child restraint and around
headrest.
Cleaning Pad
Hand wash pad with warm sudsy water, rinse clean and air
dry. Spot clean the harness straps. Do not use bleach or use
other harsh cleaners. Do not dry clean.
Do not use child restraint without the pad.
Replace child restraint pad by reversing order. Starting from
bottom of child restraint, slip pad on shell; pull harness
tightening strap through pad. Make sure pad is under headrest
and attach the fastening strip behind the headrest. Replace
lower and upper harness guides. Replace headrest pad.
Attach all of the elastic straps.
Rethread harness (see section C-9).
25
C-9 Installing Harness System
1.
Install Buckle
Fit the buckle's metal
retainer through the slot
in the child restraint. Red
button must face out.
Pull buckle's metal retainer
completely through pad
and shell from bottom of
child restraint.
2. Check Buckle
Pull up on buckle to make
sure it is secured. The
buckle must not pull out.
3. Thread Harness Strap
Thread the harness down
through slot on left side of
shell
slot on right side (2).
NOTE:
1
end of the harness strap
loop faces the buckle
2
before starting.
Take both ends of the
harness and make them
even in length.
NOTE:
tightening strap is between
the harness strap and shell
as shown.
26
(1) and up through
Make sure sewn
Make sure harness
continued on next page.