Safety 1st Grow and Go Comfort Cool Manual page 27

47
7
8
9
Attach Lower Anchor
Connectors to Vehicle's
Lower Anchors
Review your vehicle owner's
manual for lower anchor
locations and lower anchor
belt use.
Make sure arrows on
connectors are facing up.
Fasten one lower anchor belt
connector to the anchor
located in the vehicle seat
bight.
Repeat for other side of child
restraint.
Tighten Belt
Place hand in child restraint.
Firmly push child restraint down
while pulling the free end of the
belt parallel with the belt path
through the belt path opening as
shown.
Tighten Tether
Push fi rmly on the back of the
seat and pull the tether strap to
remove all slack and create
tension on the strap.
10 Check Belt Tightness
Hold child restraint at the belt
path with your weaker hand.
Push and pull from side to side.
It should not move more than
1 in. (2.5 cm).
If it moves more than 1 in. (2.5 cm), you can try:
A. Putting your knee in the seat and pulling the belt tighter.
B. Reinstalling the child restraint.
C. Changing to a different seating location.
D. Switching to vehicle belt installation.
Finished!
Check the tightness of the install
often to make sure it has not
loosened.
Securing Child in Car Seat
To properly secure your child in the
car seat, see pages 49-51.
Check your child's fi t often and
make any needed adjustments to
the car seat as they grow.
48