Table of Contents
Advertisement
Installing Harness System
69
1
Fully Recline the Child
Restraint
Pull out on recline handle and
push top of child restraint back.
2
Insert Buckle's Metal Retainer
into Slot Closest to Child
Buckle must face out.
1
2
Rear-Facing
3
the 1st or 2nd buckle slots.
Forward-Facing
can be used.
3
Reach Under Seat Between
Base and Shell and Through
Recline Handle
Pull metal retainer completely
through pad and shell.
4
Check Buckle
Pull up on buckle to make sure it
is secured.
The buckle must not pull out.
Mode: You must use
Mode: Any slot
If you have removed the harness straps from the splitter
plate, and the buckle tongues and chest clip have been
unthreaded from the harness straps, follow the steps
below to rethread them.
5
Adjust Headrest to
Highest Position
Undo Fasteners on Seat Pad
6
and Pull Headrest Pad Off
Bottom of Headrest
Unthread harness straps from
slots on side of headrest. Loosen
harness straps.
Pull chest clip, harness straps,
and buckle tongues out from
behind the headrest and seat
pad.
Pull headrest pad down around
bottom of headrest.
Slide harness straps into slots in
headrest pad.
Attach seat pad fasteners.
1
Thread Buckle and Chest
Clip
Harness strap ends go through
the back of buckle tongues and
through the chest clip front to
back as shown.
70
continued on next page
Advertisement
Table of Contents
