Aircraft Information - Safety 1st Grow and Go Comfort Cool Manual

69
2 Thread Harness Straps into
Upper Shoulder Harness Slots
If you will be using the lower
shoulder harness slots for smaller
children, see pages 15-18.
3 From Back, Thread Harness
Straps OVER Metal Bar
Do not twist harness straps.
Attach 1st Harness Strap
4
Loops to Splitter Plate As
Shown
Sewn ends of the harness strap
loops must face towards you.
Do not twist harness strap or
harness adjustment strap.
Make sure the same harness strap
loops are fitted completely on both
sides of the splitter plate.
sewn
end
If you cannot achieve a snug harness fi t for your child, see
pages 15-18. To learn how to check harness tightness, see
pages 49-51.
WARNINGS: Harness system must be installed
correctly. Failure to follow these steps can result in
serious injury or death.

Aircraft Information

This restraint is certified for aircraft use when used with the
internal harness.
This child restraint is not certified for aircraft use when used as a
booster seat because aircraft seats do not have shoulder belts.
Install the child restraint in a window seat to avoid blocking the
aisle. If the aircraft lap belt is too short, ask the flight attendant for
a belt extender.
Use only on forward-facing aircraft seats.
Contact the airline for their specific policies.
Some airlines may ask to see a label
stating that this child restraint is certified
for aircraft use.
There is an airplane certification label
located on the side of this child restraint
as shown.
WARNING:
Store lower anchor belt and tether
strap.
Rear-Facing Aircraft Installation
Follow the steps on pages 29-33.
Forward-Facing Aircraft Installation
Follow the steps on pages 40-43, skipping
the tether strap steps.
70