Installing Harness System - Safety 1st Crosstown Manual

Installing Harness System

Installing Harness System
67
Installing Buckle
1
Insert Buckle's Metal
Retainer into Buckle
Slot Closest to Child
The buckle must face out.
1
2
3
Rear-Facing Mode: You must use the 1st or 2nd buckle slot.
Forward-Facing Mode: Any slot can be used.
2
Pull Metal Retainer Completely
Through Pad and Shell
3
Check Buckle
Pull up on the buckle to make sure
it is secured.
The buckle must not pull out.
Installing Harness Straps
1 Thread Harness Strap into Hip
Harness Slot
With the sewn end of the harness
strap loop facing the buckle, thread
the harness strap down through the
hip harness slot as shown.
Pull Harness Strap Across
2
Bottom of Shell
Push the harness strap up through
the other hip harness slot.
Make sure the harness strap is
between shell and base and not
underneath only the seat pad.
Harness adjustment strap must lay above the harness strap as
shown.
3 Make Harness Strap Even
The sewn end of the harness strap
loops must face each other.
4 Thread Buckle and Chest Clip
The harness strap ends go through
the back of the buckle tongues and
through the chest clip front to back
as shown.
5 Thread Harness Straps into
Shoulder Harness Slot
68
continued on next page