Installing Harness System - Safety 1st Grand 2-IN-1 Manual

43
Cleaning Pad
Machine wash separately with cold water
on a gentle cycle. Do not use bleach.
Tumble dry separately for 10-12 minutes
on low heat. Remove immediately.
Cleaning Harness Straps
Check the harness straps often for
any wear or damage.
Spot clean using warm sudsy water and
damp cloth. Spilled food and liquids on
the child restraint may result in mold or
bacterial growth over time. These spills
could also attract insects or rodents.
Replace Pad
Starting from bottom of car seat, slip
pad on shell. Pull harness adjustment
strap through pad. Wrap pad around
the top of shell. Attach all of the
elastic straps. Install harness system,
see pages 44-47.
Do not use child restraint
without the seat pad or with
damaged harness straps. Failure
to do this can result in serious
injury or death.

Installing Harness System

1 Insert Buckle's
Metal Retainer
into Slot
The buckle must face
out.
2 Pull Metal Retainer
Completely
Through Pad
and Shell
3 Check Buckle
Pull up on the
buckle to make sure
it is secured.
The buckle must
not pull out.
4
Rethread Harness
Strap
With the sewn end
of the harness
strap loop facing
the buckle, thread
the harness strap down through the
hip harness slot.
continued on next page
44