Configuring Port Forwarding (Application List) - Zte ZXHN H108N Maintenance Management Manual

Parameter
WAN Start/End Port
Timeout
2. Configure the port trigger parameters according to the request.
3. Click Add.

8.15 Configuring Port Forwarding (Application List)

This procedure introduces how to configure the port forwarding function.
Prerequisite
The application name has been created.
Steps
1. On the navigation tree, click [Application→Port Forwarding (Application List)]. The Port
Forwarding (Application List) is displayed, see
Description
Specify the port range of the device protocol that the triggering
port maps, that is, the layer-4 port number of the packets.
Once the device accesses the triggering port, the service
between the start port and end port will be enabled.
The Start Port and End Port must be specified and meet the
following conditions.
The end port number is larger than the start port number.
The difference between the end port number and the start port
number is less than nine.
The time when no traffic occurs
Figure 63.
83