Configuring Ipv4 Policy Routing - Zte ZXHN H108N Maintenance Management Manual

Figure 28 Static Routing
Table 20 lists the parameters for the static routing configuration.
Table 20 Parameters for Static Routing Configuration
Parameter
WAN Connection
Network Address
Subnet Mask
Gateway
2. Select one WAN connection from the WAN Connection drop-down list, and then specify other
parameters.
3. After the configuration, click Add.

6.4.3 Configuring IPv4 Policy Routing

This procedure introduces how to configure the policy routing for the specified WAN connection.
Prerequisite
Before configuring policy routing, make sure that the
Context
Policy routing is a routing rule. When it is configured, the packets are forwarded based on the routing
policy. The ZXHN H108N supports packet forwarding based on the DSCP, source or destination
address, protocol, source port number, or source
Steps
1. On the navigation tree, click [Network→Routing(IPv4)→ Policy Routing]. The policy routing
configuration page is displayed, see
Description
WAN connection for static routing
Destination network address
Subnet mask
Gateway of the network segment which the network interface
belongs to
WAN
MAC
Figure 29.
46
connection settings are complete.
address.
IP