Configuring Ssid Settings - Zte ZXHN H108N Maintenance Management Manual

Parameter
Transmitting Power
QoS Type
RTS Threshold
DTIM Interval
2. Select Enabled from the Wireless RF Mode drop-down list to enable the wireless transmission
function, and then select the transmission mode. For example, select IEEE 802.11n Only from
the Mode drop-down list, and specify the other parameters according the request.
3. After the configuration, click Submit.

6.2.2 Configuring SSID Settings

The ZXHN H108N device supports four SSIDs and each SSID supports up to 32 subscribers.
This procedure introduces how to configure the SSID settings.
Steps
1. On the navigation tree, click [Network→ WLAN→ SSID Settings]. The SSID setting page is
displayed, see Figure
Figure 13 SSID Settings
Table 11 lists the SSID parameters.
Description
Select the transmitting power as required.
There are three QoS types:
Disable
WMM
SSID
The default QoS type is WMM.
Specify the request to send threshold for a packet. When a
packet exceeds this value, the device sends the RTS value to the
destination point for negotiation. The default is 2347.
Range: 1 ~ 5
Default: 1
13.
30