Avery Dennison SNAP 700 User Manual page 89

User's Manual—SNAP™ 700 Printer
5. Create a sub-assembly of the Plastic Collet, the Fiber Optic Slide Shaft, The Fiber Optic
Cable and the O-Ring.
Slide the two cables at the rear of the Fiber-Optic Assembly through the Collet as shown.
This must be done by sliding one cable through, then sliding cable end of the other cable
through parallel to the first. They will not go through together.
6. From the back of the Upright Frame, slide the Collet / Cable Assembly through the ¾
diameter hole and secure with (2) 10-32 x 3/8 Button Head Screws.
10-32 X 3/8 Button
Head Screws
All manuals and user guides at all-guides.com
COLLETT
FIBER-OPTIC CABLE
SLIDE SHAFT
89
"O" RING