Feeding The Stock; Option Menu System - Avery Dennison SNAP 700 User Manual

34
mark, the light will flash rapidly or stay on.
To align the sensor to the sense mark, move the stock so that the sensor mark
shows in the slot under the sensor. Then adjust the sensor across the web until
the Supply light flashes rapidly or stays on. For best alignment, move the
sensor to the point where the light flashes most rapidly, and then continue to
move the sensor in the same direction until the light starts to flash more
slowly. Then move the sensor back to a point in between those two points.
Press Start again to begin printing.

3.3.7 Feeding the stock

3.4 Option Menu System

All manuals and user guides at all-guides.com
To feed the stock, press and hold the Start button. After a short delay, the printer
will feed stock though the printer. To stop the feed, release the Start button.
If you are in the middle of printing a batch, feeding the
stock will cause the printed labels between the printhead
and the knife to feed through without cutting. These
labels will be re-printed the next time you start printing.
The batch quantity will be correct.
The Option Menu System allows you to
Print test labels
•
Set the voice volume
•
When the instructions say to press a button, press the
button for a short time and release it. When the
instructions say to press and hold a button, press the
button and hold it down until the printer responds.
When you are in the Option Menu System, you can get out
by pressing and holding the Voice button until the printer
says "Returning to print mode."
Use the Start / Stop and Voice buttons to move through the Option Menu
System. Each time you press a key, a voice message will follow, or the machine
will initiate or stop an action. Regardless of which of the three functions you
want to select in the Option Menu System, you select it the same way:
1. Press and hold the Voice button for about two seconds.
2. The Voice message will say, "Press Start for Test Pattern."
3. If you do not want to run a test pattern, press the Voice button.
User's Manual—SNAP™ 700 Printer