Addendum Ii - Short Feed; Short Feed O-Ring Replacement - Avery Dennison SNAP 700 User Manual

All manuals and user guides at all-guides.com
149
User's Manual—SNAP™ 700 Printer
Addendum II – Short Feed
Machines equipped with short feed option use different parts noted after O-ring replacement
instructions. Machines with short feed option have ability to handle labels as short as .66" long.
O-rings on short feed nip rollers are wear items and require occasional changing. It is recommended
to change all O-rings at same time.

Short Feed O-Ring Replacement

1. Separate knife assembly from nip roller assembly by removing (2) nip assembly mount screws (shown below.
NIP ROLLER ASSEMBLY
KNIFE ASSEMBLY
NIP ASSEMBLY MOUNT SCREW
2. Remove bridge blade and static brush from nip roller assembly by loosening (2) static brush thumb screws. Remove
any worn or damaged o-rings from rubber rollers and replace with new o-rings. Rubber rollers are secured to nip roller
brackets by tension from o-rings. Stretch o-rings over nip roller brackets, then direct rubber roller ends to ½ slots on nip
roller brackets. See below.