Avery Dennison SNAP 700 User Manual page 74

74
Voice Message
Internal error. Press MCB CMD_FRE INDEX ERR
start to continue. MCB CMD_FSE INDEX ERR
MCB BAD STACK ERROR
MCB KNF FLIT TBL TOO
BIG
MCB KNIFE STATE TOO
BIG
MCB KNIFE STATE TOO
BIG
MCB BEMF MON ST TOO
BIG
MCB STACKR HM ST TOO
BIG
MCB KNF HOME ST TOO
BIG
MCB BEMF CTRL ST TOO
BIG
MCB
OVERFLOW
MCB FVE INDEX ERROR
MCB ERROR #58
MCB ERROR #59
MCB ERROR #60
MCB ERROR #64
MCB ERROR #68
MCB ERROR #69
MCB ERROR #70
MCB ERROR #91
MCB ERROR #95
MCB ERROR #97
MCB ERROR #98
MCB ERROR #99
Internal error. Press OUT OF MEMORY
start to continue. IMAGER ERROR
Knife cycle error. LBL
Increase label length SPEED
or select a slower
print speed.
The stock supply roll STOCK OUT
is empty
All manuals and user guides at all-guides.com
Prompt
SHE BATCH Q
919
TOO SHORT FOR
User's Manual—SNAP™ 700 Printer
Description
These are internal software errors. If one of them
occurs, clear the error and continue.
continues to occur, report the error and the
circumstances that cause it to Avery Dennison
Service. These errors are caused by errors in the
software and are not caused by hardware failures.
These are internal errors similar to the ones above.
However, these errors will require power cycling the
printer. If the error continues to occur, report the
error and the circumstances that cause it to Avery
Dennison Service.
This error indicates that the label is shorter than the
minimum length for the selected print speed. Refer
to the Printer Specifications for minimum label
lengths. (Minimum label lengths are different for the
Sonic Knife. Refer to the Sonic Knife manual.) To
run and cut the label, you must either make the label
longer or reduce the print speed.
This error indicates the stock supply roll is empty. If
the stock supply roll is not empty, make sure the
supply core is firmly held by the arbor clamp.
If this error continues to occur, remove the stock roll
and press the Start button (the Ready light must be
on). The stock arbor should spin counter-clockwise
briefly. If it doesn't, the motor or MCB is defective. If
it spins and you continue to get the error after re-
installing the stock roll, the MCB is defective.
If the error