Avery Dennison SNAP 700 User Manual page 27

User's Manual—SNAP™ 700 Printer
All manuals and user guides at all-guides.com
roll. To avoid damaging the rollers or print heads, use scissors to cut off any
portion of the supply stock that has adhesive on it.
2. Rotate the unwind knob clockwise to retract the "fingers". Open the
assembly so the back locator hub and front locking fingers are wider that the
material.
3. To install the stock supply roll, begin with the leading end at the top of the
roll pulling off towards the stacker.
4. Slide the stock roll onto the Stock Arbor (see Figure 9).
5. Rotate the Stock Arbor knob counter-clockwise quickly to extend the fingers
that hold the supply roll in place.
6. With all print rollers in the open position, pull the stock from the top of the
supply roll, and over the Decurler Roller.
Decurler Roller
Retraction
Fingers
Figure 9. Stock Supply through Print Stations
7. Pull the roll of stock to the right of the Stock (web) guides.
8. Feed the web between the two plates that support the registration sensors
9. Continue threading the stock between the print rollers and through the feed.
10. Rotate the black knob on the feed counter-clockwise and advance the stock
through the knife and nip rollers and into the stacker (until it extends about
½ inch or 10 mm - 15 mm from the rollers).
11. If the stock will not advance through the knife, refer to Section 5.4.2, Knife
Home Position Adjustment.
Lower Print Station
Upper Print Station
Stock (Web) Guide
Stock Arbor Knob
27