Checking The Main Fuse Configuration - Avery Dennison SNAP 700 User Manual

18

2.5.2 Checking the Main Fuse Configuration

All manuals and user guides at all-guides.com
WARNING: Before powering on the printer, you must
check to be sure the main fuses on the AC power
receptacle are set for the appropriate voltage for your
location (Line voltage of 90-132VAC @ 50-60Hz, single
phase or 180-265VAC @ 50-60Hz, single phase).
The main fuse(s) on the SNAP 700 printers are located inside the AC power entry
receptacle on the backside of the printer (see Figure 5). The AC power entry has
a fuse drawer that holds the fuse(s) and selects the appropriate line voltage.
1. Look at the line voltage level shown in the window on the back of the printer
(see Figure 1). If the number in the window matches the appropriate voltage
for your location, you can proceed with setting up your printer.
2. If the line voltage does not match the voltage for your location, contact your
local AVERY DENNISON supplier. To change the Fuse Configuration, see
Appendix 1.
In the U.S.A., call (937) 865-2123.
•
Outside the U.S.A., please contact your local AVERY DENNISON supplier.
•
WARNING: Some printers require internal changes when
switching the line (mains) voltage from 115V to 230V.
Refer to Appendix 1 for instructions. Failure to follow the
instructions may result in damage to the printer.
CAUTION: If the number in the window DOES NOT match
the AC power line intended to be supplied to the printer,
DO NOT plug in the power cord.
WARNING: Attempting to open the AC power entry with
the AC power cord already inserted will damage the AC
entry.
Figure 5. Right Side of Printer – Rear View
User's Manual—SNAP™ 700 Printer
115V Fuse Line
Voltage Setting