Avery Dennison SNAP 700 User Manual page 50

50
Figure 17a. Unplugging Print Head Cable
Figure 17c. Print Head Assembly – Removed
All manuals and user guides at all-guides.com
printer.
7. To remove the head lift slightly on the outer end of the head to lift it off the
locating pins. Pull the head towards the stacker end of the printer. It will
slip out from under the flat retaining springs located at both ends of the
head.
8. Unplug the two cables that connect to the print head by grasping the print
head cable, rocking it gently (see Fig. 17a). Remove the print head assembly
from the print station (see Fig. 17b).
9. Place the new print head assembly onto the print station (see Fig. 17c and
17d).
10. Reconnect the two print head cable connectors, making sure that the
connectors are seated tightly.
11. Slide the head mounting plate under the two flat retaining springs until it
clicks into position.
WARNING: If the cables are not connected correctly, the print
head could be destroyed when the power to the printer is
User's Manual—SNAP™ 700 Printer
Figure 17b. Print Head released from springs
Figure 17d. Inserting Print Head Assembly