Service Adjustments; Tape (Web) Guide Position; Tape (Web) Guide Width Adjustments; Auxiliary Feed - Avery Dennison SNAP 500 Adidas User Manual

54

6.0 Service Adjustments

6.1 Tape (Web) Guide Position

6.2 Tape (Web) Guide Width Adjustments

6.3 Auxiliary Feed

6.4 Knife Shear Adjustment

All manuals and user guides at all-guides.com
The tape (web) guide is set at the factory to center the tape to the printed image.
If a slight mechanical adjustment is needed, follow these steps.
1. Locate the two screws under the Tape (Web) Guide mount plate.
2. Open the web guides to the widest position by turning the knob above the
guide clockwise.
3. Loosen the two screws.
4. Move the guide to the position desired.
5. Re-tighten the screws.
Use the knob to move the guides until they touch the edges of the tape.
The Auxiliary Feed is the assembly located in front of the knife. It works with
the main feed or the top print roller to maintain proper tension of the tape as it
moves through the printer from the top print station into the Knife and Nip
rollers.
NOTE: The upper print roller must be closed in order for
the tape to feed through the printer.
If the tape will not advance through the Knife, check to be sure the knife is in the
home position (see Sect. 5.4.2, Knife Home Position Adjustment).
The Knife Assembly in your AVERY DENNISON SNAP 500 printer has no field
replacement components, and basically requires no maintenance or adjustments.
The only adjustment that can be made to the knife in the field is for shear.
WARNING: Knife adjustments procedure must be followed
exactly or damage will occur.
WARNING: When adjusting, removing, or replacing the
knife assembly, you must turn off the power to the printer
to avoid personal injury.
User's Manual—SNAP™ 500 Adidas Printer