Installation
1. Place the thermostat in thermostat housing.
(1) Install the thermostat with the jiggle valve upward.
(2) Install a new thermostat (B).
2. Install the water inlet fitting (A).
Tightening torque :
16.7 ~ 19.6N.m (1.7 ~ 2.0kgf.m, 12.3 ~ 14.5lb-ft)
3. Fill with engine coolant.
4. Start engine and check for leaks.
Engine Mechanical System > Cooling System > Thermostat > Troubleshooting
Troubleshooting
Symptoms
Coolant
• From the
leakage
thermostat gasket
Possible Causes
Check the
• Check the torque of the
mounting bolts
Check the gasket
• Check gasket or seal for
for damage
mounting bolts
Remedy
• Retighten the bolts and
check leakage again.
• Replace gaskets and