Hyundai GENESIS COUPE BK 2010 Manual page 429

Fig.1) Normal waveform of CKPS & IN-CMPS at idle.
Fig.2) Normal data of IN-CVVT at idle.
Fig.3) Normal data of IN-CVVT at acceleration with load.
Fig.4) Normal graph of IN-CVVT at acceleration with load.
This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveform at
idle.(Fig1.) If the 17th signal of the CKPS after missing tooth is aligned with the high signal of the CMPS at idle, ECM
recognizes that Synchronization between CKPS and CMPS is completed. Under acceleracting condition, the number of
tooth between missing tooth and tooth aligned with edge of the CMPS high signal is decreased than idle condition.
Monitor GDS Data
1. Connect GDS to Data Link Connector(DLC).
2. IG "ON".
3. Select "DTC" button, and then Press "DTC Status" to check DTC's information from the DTCs menu.