Fig.1) Normal waveform of CKPS & CMPS at idle.
This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveform at
idle. If the 17th signal of the CKPS after missing tooth is aligned with the high signal of the CMPS at idle, ECM
recognizes that Synchronization between CKPS and CMPS is completed.
Monitor GDS Data
1. Connect GDS to Data Link Connector(DLC).
2. IG "ON".
3. Select "DTC" button, and then Press "DTC Status" to check DTC's information from the DTCs menu.
4. Read "DTC Status" parameter.