Hyundai GENESIS COUPE BK 2010 Manual page 134

6. Install the thrust bearings.
Install the 2 thrust bearings(A) under the No.3 journal position of the cylinder block with the oil grooves facing
outward.
7. Place the crankshaft(A) on the cylinder block.
8. Place the main bearing caps on cylinder block.
9. Install the main bearing cap bolts.
(1) Install and uniformly tighten the bearing cap bolts, in several passes, in the sequence shown.
Tightening torque
Main bearing cap bolt
49.0N.m (5.0 kgf.m, 36.2lb-ft) + 90° (1 ~ 8)
19.6N.m (2.0 kgf.m, 14.5lb-ft) + 120° (9 ~ 16)
29.4 ~ 31.4N.m (3.0 ~ 3.2 kgf.m, 21.7 ~ 23.1lb-ft) (17 ~ 24)
• Always use new main bearing cap bolts.
• If any of the side bearing cap bolts are broken or deformed, replace it.