Hyundai GENESIS COUPE BK 2010 Manual page 359

Fuel System > Engine Control System > Canister Close Valve (CCV) > Repair procedures
Inspection
1. Turn the ignition switch OFF.
2. Disconnect the CCV connector.
3. Measure resistance between the CCV terminal 1 and 2.
4. Check that the resistance is within the specification.
Specification: Refer to "Specification"
5. Disconnect the vapor hose connected with the canister from the CCV.
6. Connect a vacuum pump to the nipple.
7. Ground the CCV control line and apply battery voltage to the CCV power supply line.
8. Apply vacuum and check the valve operation.
Specification: Vacuum maintained
Fuel System > Engine Control System > Troubleshooting
Inspection Chart For Diagnostic Trouble Codes (DTC)
DTC
P0011 "A" Camshaft Position-Timing Over-Advanced or System Performance (Bank 1)
P0012 "A" Camshaft Position-Timing Over-Retarded (Bank 1)
P0014 "B" Camshaft Position -Timing Over-Advanced or System Performance (Bank 1)
P0015 "B" Camshaft Position -Timing Over-Retarded (Bank 1)
P0016 Crankshaft Position–Camshaft Position Correlation (Bank 1 Sensor A)
Description MIL
●
●
●
●
●