Hyundai GENESIS COUPE BK 2010 Manual page 162

When remove the oil filter element from the oil filter cap, pull the oil filter element upright.
(6) Apply clean engine oil to the new O-ring.
Lightly screw the oil filter cap into place, and tighten it until the O-ring contacts the seat.
(7) Finally tighten it again by specified tightening torque.
Tightening torque :
31.4 ~ 38.2N.m (3.2 ~ 3.9kgf.m, 23.1 ~ 28.2lb-ft)
6. Fill new engine oil.
(1) Install the oil drain plug with a new gasket.
Tightening torque :
34.3 ~ 44.1N.m (3.5 ~ 4.5kgf.m, 25.3 ~ 32.5lb-ft)
(2) Fill with new engine oil, after removing the engine oil level gauge.
Capacity
Total : 6.0 L (6.34 US qt, 5.27 lmp qt)
Oil pan : 5.5 L (5.81 US qt, 4.83 lmp qt)
Drain and refill including oil filter :
5.2 L (4.49 US qt, 4.57 lmp qt)
• Fill a half oil of the total amount first and do the rest again after about one minute later.
• Do not fill oil over the 'F' line, checking the level with the oil level gauge.
(3) Install the oil filler cap and oil level gauge.
7. Start the engine and check to be sure no oil is leaking from the drain plug or oil filter.
8. Recheck the engine oil level.
Engine Mechanical System > Intake And Exhaust System > Intake Manifold > Components
and Components Location
Components