2. Measure resistance between power and signal terminals of OCV. (Component Side)
Specification : 6.7 ~ 7.7 at 20°C (68°F)
3. Is the measured resistance within specification?
▶ Go to "OCV Actuation Test" as follows.
▶ Substitute with a known - good OCV and check for proper operation. If the problem is
corrected,
replace OCV and go to "Verification of Vehicle Repair" procedure.
■ OCV Actuation Test
1. Connect GDS and IG "ON"
2. Select "Exhaust Oil Control Valve" on the Actuation Test
3. Activates "Exhaust Oil Control Valve" by pressing "START" button
(Should hear a faint click from Oil Control solenoid Valve)
4. Repeat this procedure 4 or 5 times to ensure oil control solenoid valve reliability
5. Does OCV generate click sound during acutation test ?
▶ Substitute with a known - good ECM and check for proper operation. If the problem is
corrected,
replace ECM and go to "Verification of Vehicle Repair" procedure.