8. Install the air cleaner assembly (C) and then connect the AFS connector (B).
9. Install the air duct (A).
Tightening torque :
Bolt : 7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
Clamp : 2.9 ~ 4.9N.m (0.3 ~ 0.5kgf.m, 2.2 ~ 3.6lb-ft)
10. Connect the battery negative cable.
• Refill engine coolant.
• Refill radiator and reservoir tank with engine coolant.
• Bleed air from the cooling system.
- Start engine and let it run until it warms up. (Until the radiator fan operates 3 or 4 times.)
- Turn Off the engine. Check the level in the radiator, add coolant if needed. This will allow trapped air to be
removed from the cooling system.
- Put radiator cap on tightly, then run the engine again and check for leaks.
• Clean the battery posts and cable terminals with sandpaper. Assemble and, then apply grease to prevent
corrosion.
Engine Mechanical System > Intake And Exhaust System > Muffler > Components and
Components Location
Components