2. IG "ON".
3. Select "DTC" button, and then Press "DTC Status" to check DTC's information from the DTCs menu.
4. Read "DTC Status" parameter.
5. Is parameter displayed "Present fault"?
▶ Go to "System Inspection" procedure.
▶ Fault is intermittent caused by ECM memory was not cleared after repair. Erase DTC and drive
the vehicle to satisfy the enable codition then, go to " System Inspection" procedure.
System Inspection
■ Visual Inspection
1. Check oil level is O.K.
2. Check oil and OCV is contaminated.
3. Check for oil leakage around OCV.
4. Has a problem been found ?
▶ Repair or replace as necessary and then, go to "Verification of Vehicle Repair" procedure.
▶ Go to "Component Inspection" procedure
Component Inspection
■ Check OCV resistance
1. IG "OFF" and disconnect OCV connector..
2. Measure resistance between power and signal terminals of OCV. (Component Side)
Specification : 6.7 ~ 7.7 at 20°C (68°F)
3. Is the measured resistance within specification ?
▶ Go to "Check CAM PHASER with actuation test" as follows.
▶ Substitute with a known - good OCV and check for proper operation. If the problem is
corrected,
replace OCV and go to "Verification of Vehicle Repair" procedure.