Displaying Poe Configuration; Displaying The Current Poe Configuration - Avaya 3500 Series Getting Started

[no] snmp-server notification-control {pethPsePortOnOffNotification
| pethMainPowerUsageOnNotification |
pethMainPowerUsageOffNotification}
Variable definitions
The following table describes the parameters for the snmp-server notification-control
command.
Variable
pethPsePortOnOffNotification |
pethMainPowerUsageOnNotification |
pethMainPowerUsageOffNotification
no

Displaying PoE configuration

You can display the status for the PoE configuration on the PWR+switch.

Displaying the current PoE configuration

Display the current PoE configuration of the PWR+switch, and settings for each PoE port.
Procedure
1. Enter Privileged EXEC mode:
enable
2. At the command prompt, enter the following command:
show poe-main-status [unit <1–8>]
Example
The following figure provides a sample output of the show poe-main-status command.
switch#show poe-main-status
PoE Main Status - Stand-alone
---------------------------
Available DTE Power
DTE Power Status
DTE Power Consumption
DTE Power Usage Threshold
PD Detect Type
Power Source Present
AC Power Status
DC Power Status
July 2015
Value
Specifies a notification type
Disables the traps for the PoE function
: 370 Watts
: Normal
: 0 Watts
: 80 %
: 802.3at and Legacy
: AC Only
: Present
: Not Present
Comments on this document? infodev@avaya.com
Displaying PoE configuration
Getting Started with Avaya ERS 3500 Series
105